Scantronic 808 Guia do Utilizador descarregar pdf (Página 7)

496235 Issue 1 7

Note: Some Levels on your system may be programmed for Silent Set. When

setting these Levels the system does not give any tones from the keypads.

Final Exit

With Final Exit setting the system sets when you close the last door. There is

no fixed exit time.

1. Close all doors and windows.

2. Key in your access code at the keypad.

3. Press the appropriate Level button.

The keypad starts the continuous exit tone, the

Level LED flashes, and the display shows: READY LEAVE

4. Leave via the designated exit route and close the final door.

The system sets and stops the exit tone seven seconds after you close

the final door. The Level LED glows to show which Level is set.

Exit Terminate Button

In Exit Terminate Button setting the system completes setting after you press

a button mounted outside the premises by the final door.

1. Close all doors and windows.

2. Key in your access code at the keypad.

3. Press the appropriate Level button.

The keypad starts the continuous exit tone, the

Level LED flashes, and the display shows: READY LEAVE

4. Leave via the designated exit route. Close the final door.

5. Press the exit terminate button.

The exit tone stops and the system sets.

Note: The Installer may have programmed your system to set after a fixed time even

if you do not press the exit terminate button. This is to make sure your

premises are protected even if you forget to press the exit terminate button.

Ask your Installer how your system is set up.

Instant Set

With Instant Setting the system sets as soon as you complete entering the

set command from the keypad.

1. Close all doors and windows.

2. Key in your access code at the keypad.

3. Press the appropriate Level button.

The system sets immediately. The Level LED glows to show which

Level is set.

2. Everyday Operation

1 2 3 4 5 6 7 8 9 10 11 12 ... 25 26

Sem comentários

Scantronic 808 Guia do Utilizador Página 7