Scantronic 9800+ Guia do Utilizador descarregar pdf (Página 11)

496334 Issue 1 11 of 14

To change: Key-in: Notes Default

Test keypad sounder 94 Keypad sounder operates

Clear Keypad sounder test ends

Test output 1 95 Programmable output 1 operates

Clear Output 1 test ends

Test output 2 96 Programmable output 2 operates

Clear Output 2 test ends

Walk Test 97 Zone LED and sounder operate when

circuit open

Clear End walk test

Load defaults 98 Load defaults

Leave programming 99

Leaving Programming Mode

When all programming has been completed:

1. Key-in ‘99’ at the keypad.

The display clears and the Day LED is ON.

The system is now in user mode.

Note: If there is a fault on the system , for example an open tamper circuit, the

display shows this and will not return to Day mode. Press

(Clear) and rectify

the faults.

Engineer Reset

To perform an Engineer Reset:

1. Check that the display is showing the alarm condition. (Note: if the

display shows “rr”, Press Clear twice.)

2. Key in 0 followed by the Engineer’s code (default 7890), followed by 99.

The display goes blank and the Day LED glows.

Re-Entering Programming Mode

“Initial Power Up” describes how to enter programming mode for the first time

in a new installation. If you wish to enter programming mode at any other

time:

1. Make sure the system is unset.

2. Press 0, then key in the Engineer’s code (default 7890).

The keypad gives an intermittent tone.

3. Open the end station lid.

The display shows “E” (for ‘engineer’) and the intermittent tone stops.

You are now in programming mode.

9800 Leaving Programming Mode

1 2 ... 6 7 8 9 10 11 12 13 14

Sem comentários

Scantronic 9800+ Guia do Utilizador Página 11