Scantronic 9800+ Guia do Utilizador descarregar pdf (Página 7)

496334 Issue 1 7 of 14

Programming

Initial Power Up

When all wiring is complete, power up the system for the first time as follows:

1. Ensure that the keypad(s) and detectors are securely fitted and their

tamper switches closed.

2. Connect the battery and then close the case.

3. Switch on the mains power. Ignore any tones from the internal and

keypad sounders.

4. Go to a keypad and key in 1234.

5. Key in 0 followed by 7890 (the default Engineer’s code).

The keypad gives an intermittent tone.

6. Open the end station lid. (If the lid is already open, close and open the

tamper switch.)

The displays shows “E” (engineer).

You are now in programming mode.

Programming Commands

When delivered from the factory the control unit already has default program

settings. To change the default programming you must be in programming

mode. Then:

1. Key in the appropriate command number.

The display shows the current value of the command.

2. Key in digits to select the value you require.

The display shows a code giving the new value.

3. Press Clear to store the new value of the command.

If at any time you change your mind, repeat step 1 to 3. The table on the

following pages shows the commands and their options. ( A y next to a

command value shows that it is the factory default.)

The factory default access codes are:

Engineer Code 7890

Access Code User 1 1234

Access Code 2 to 4 AAAA (inactive)

Access Code 3 BBBB (inactive)

Access Code 4 CCCC (inactive)

Duress Code OMIT, OMIT, OMIT, OMIT (inactive)

Note: The factory default Access Codes 02 to 04 and the Duress Code must be

changed by USER 1 to a four digit number to activate them.

9800

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Sem comentários

Scantronic 9800+ Guia do Utilizador Página 7